sl power electronics, corp.. 6050 king dr. bldg. a ventura, ca 93003 + 805-486-4565 model numbers: glc50x -yyyg, where x represents the output volta ge selected from the table below, -yyy represents value added options not related to safet y and g represents compliance to rohs. model may b e followed by suffix ?c for chassis & cover option. r a t i n g s input: 100-240 vac, 1.4 a, 50/60 hz output: model 1 watts 2 output #1 output #2 output #3 GLC50A 50 +5.05vdc 4a +12vdc 2.5a -12vdc 0.2a glc50b 50 +5.05vdc 4a +15vdc 2.5a -15vdc 0.2a glc50d 50 +5.05vdc 4a +24vdc 1.5a -12vdc 0.2a glc50g 50 +3.3vdc 4a +12vdc 2.5a -12vdc 0.2a notes: 1. model may be followed by -c for chassis & cover option. 2. -c option requires 24 cfm minimum airflow for fu ll rated output power. 3. maximum operating ambient is 50c. 4. maximum relative humidity 96%, no condensation. safety declaration: sl power electronics corp. (slpe). declares under o ur sole responsibility that all models listed above are in conformity with the applicable requirements of en60950 following t he provisions of the low voltage directive 2006/95/ec. all models are certified to be in compliance with the applicable requirements of en/iec/ul 60950-1 1 st ed., csa 22.2 no. 60950-1-03 1 st ed. for pollution degree 2 environment and class i tn-s power systems. the out puts of the supplies meet the requirements for selv and are not an energy hazard. the ground terminal must be bonded to earth in the end application. using this terminal for the prima ry system earthing terminal is not recommended. chassis and cover installation: the insulator prov ided with the chassis and cover must be installed o n the j1 side of the enclosure. creepage and clearance dist ances from primary circuits to ground and secondary circuits, as defined in the applicable safety standards, must be maintained after installation to preserve the intended safety . the maximum operating temperatures of certain safet y components, as defined in the applicable safety s tandards, must not be exceeded after installation to preserve the intende d safety. the output power, ambient air temperatur e and the availability, amount, direction and/or restriction of airflow inf luence the temperatures of these components. warning! risk of fire! a blown fuse is an indication of catastrophic failu re of circuit component(s). repair must be perform ed by slpe authorized personnel. fuse f1 must be replaced with t 2a 250v (slow blow), ul listed and csa certified type. c o n n e c t i o n s j1 pin ac input j2 pin dc output 1 line 1 output #2 (+) 3 neutral 2 output #1 (+) 3 output #1 (+) 4 common 5 common 6 output #3 (-) slpe will not be liable for the safety, reliability or performance of these power supplies if a) any c hanges, modifications or repairs are carried out by other than authorized agents of slpe, or b) the installation of the supply is not i n accordance with these installation instructions a nd the applicable ul, csa, iec and/or en safety sta ndards. 41-34472-0001 rev. e 03/26/08 installation instructions glc50 multi output series mating connectors j1 amp housing 640250-3 contact 770522 j2 amp housing 640250-6 contact 770522
|
